NEW 900 Mhz. Rabbit Receiver Information Sheet
Rabbit™ Receivers

Rabbit™ Receivers use Frequency Hopping Spread Spectrum protocols in the 900MHz ISM band.  
This enables many of them to be used at the same time without concern for being shot down, without
any frequency control boards.  
 ( available with 1 or 2  Antenna leads )

Benefits

*        Freedom from frequency control – just switch on and fly without concern for
  interaction with other fliers
*       Fly up to 20 planes simultaneously
*        Multi-channel operation with high resolution fully proportional control
*        Excellent immunity from radio interference


Specifications

*        900 Mhz Frequency Hopping Spread Spectrum
*        Full Hip-Hop™ protocol
*        4 Fully proportional channels
*        150 ohm actuators (Rabbit™ 4) or 20 ohm actuators (Rabbit™ 3A)
*        Servo out put available  (Rabbit™ Srevo)
*        On-board brushed motor ESC for motors of at least 5 ohms
*        available with  Brushless Motor Output
*        Resolution 64 steps each side of neutral , and 64 steps of throttle
*        Frame rate 30 fps
*        Dimensions 0.2” x 0.2” x 0.1”  =  5mm x 5mm x 2.5mm
*        Weight 115 mg (0.004 oz) (Rabbit™ 4), 135 mg (0.005 oz) (Rabbit™ 3A)
( Back to Receivers )